Toyota Camry (XV70): Vehicle Control History
Toyota Camry Repair Manual XV70 (2018-2024) / Drivetrain / Ua80e (automatic Transmission / Transaxle) / Automatic Transaxle System / Vehicle Control History
VEHICLE CONTROL HISTORY
VEHICLE CONTROL HISTORY
HINT:
A part of the control history can be confirmed using the vehicle control history.
Click here .gif)
READ NEXT:
System Voltage Circuit Short to Ground or Open (P056014)
DESCRIPTION The battery supplies electricity to the ECM even when the engine switch is off. This power allows the ECM to store data such as DTC history and freeze frame data. If the battery voltage fa
Vehicle Speed Sensor "A" No Signal (P050031)
DESCRIPTION The speed sensor detects the wheel speed and sends the appropriate signals to the skid control ECU. The skid control ECU converts these wheel speed signals into a pulse signal and outputs
Starter Relay Circuit Short to Battery (P061512)
DESCRIPTION While the engine is being cranked, battery voltage is applied to terminal STA of the ECM.
If the ECM detects the starter control (STA) signal while the vehicle is being driven, it determ
SEE MORE:
Approach warning (vehicle-to-vehicle distance control mode) - Dynamic radar cruise
control with full-speed
range
When your vehicle is too close to
a vehicle ahead, and sufficient
automatic deceleration via the
cruise control is not possible, the
display will flash and the buzzer
will sound to alert the driver. An
example of this would be if
another driver cuts in front of you
while you are following a
Removal
REMOVAL PROCEDURE 1. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
Click here 2. REMOVE V-RIBBED BELT
Click here 3. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
(a) Remove the bolt and No. 2 idler pulley sub-assembly.
4. REMOVE WATER PUMP PULLEY
(a) Using a screw
© 2023-2024 Copyright www.tocamry.com
