Toyota Camry (XV70): Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Perform the removal and installation of the front disc brake piston, cylinder boot and piston seal one side at a time.
PROCEDURE
1. REMOVE FRONT DISC BRAKE PISTON
| (a) Place a piece of cloth and a wooden block between the front disc brake piston and front disc brake cylinder. HINT: Make sure to place the wooden block between the front disc brake piston which is not to be removed and the front disc brake cylinder. |
|
(b) Apply compressed air to remove the front disc brake piston from the front disc brake cylinder.
CAUTION:
- Do not hold the front disc brake cylinder with any part of your hand between the front disc brake cylinder and front disc brake piston.
- Do not place any part of your hand in front of the front disc brake piston when using compressed air as a severe injury may result.
NOTICE:
Do not allow any brake fluid to spatter.
2. REMOVE CYLINDER BOOT
|
(a) Using a screwdriver with its tip wrapped with protective tape, remove the cylinder boot from the front disc brake cylinder. NOTICE: Be careful not to damage the front disc brake cylinder. |
|
3. REMOVE PISTON SEAL
|
(a) Using a screwdriver with its tip wrapped with protective tape, remove the piston seal from the front disc brake cylinder. NOTICE: Do not damage the inner surface or piston seal groove of the front disc brake cylinder. |
|
4. REMOVE FRONT DISC BRAKE BLEEDER PLUG CAP
(a) Remove the front disc brake bleeder plug cap from the front disc brake bleeder plug.
5. REMOVE FRONT DISC BRAKE BLEEDER PLUG
(a) Remove the front disc brake bleeder plug from the front disc brake cylinder.
READ NEXT:
Inspection
INSPECTION PROCEDURE 1. INSPECT BRAKE CYLINDER AND PISTON
(a) Check the front disc brake cylinder bore and front disc brake piston for rust and scoring. If necessary, replace the front disc brake cy
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT
HINT: Perform the removal and installation of the front disc brake piston, cylinder boot and piston seal one side at a time. PROCEDURE
1. TEMPORARILY TIGHTEN FRO
Installation
INSTALLATION CAUTION / NOTICE / HINT
NOTICE:
Immediately after installing the front disc brake pads, the braking performance may be reduced. Always perform a road test in a safe place while payi
SEE MORE:
Cargo and luggage
Take notice of the following information about storage precautions,
cargo capacity and load:
Capacity and distribution
Cargo capacity depends on the total weight of the occupants.
(Cargo capacity) = (Total load capacity) - (Total weight of occupants)
Steps for Determining Correct Load Limit -
Using the storage
features
List of storage features
Auxiliary boxes
Glove box
Bottle holders/door pockets
Cup holders
Console box
Auxiliary box/open tray
Coin holder
WARNING
Do not leave glasses, spray cans in the storage spaces, as this
may cause the following when cabin temperature becomes high:
