Toyota Camry (XV70): Inspection
INSPECTION
PROCEDURE
1. INSPECT BRAKE DISC INSIDE DIAMETER
| (a) Using a brake drum gauge or an equivalent tool, measure the inside diameter of the rear disc. Standard Inside Diameter: 173 mm (6.81 in.) Maximum Inside Diameter: 174 mm (6.85 in.) If the inside diameter is more than the maximum, replace the rear disc. |
|
2. INSPECT PARKING BRAKE SHOE LINING THICKNESS
| (a) Using a ruler, measure the thickness of the parking brake shoe lining. Standard Thickness: 3.5 mm (0.138 in.) Minimum Thickness: 1.0 mm (0.0394 in.) If the lining thickness is less than the minimum, or if there is severe or uneven wear, replace the parking brake shoe assembly. NOTICE: Always replace both right and left parking brake shoes together. |
|
3. INSPECT BRAKE DISC AND PARKING BRAKE SHOE LINING FOR PROPER CONTACT
| (a) Apply chalk to the inside surface of the rear disc, then slide the parking brake shoe against the rear disc to check the fit of the parking brake shoe lining to the rear disc. If the contact between the rear disc and parking brake shoe lining is incorrect, repair it using a brake shoe grinder or replace the parking brake shoe assembly. NOTICE:
|
|
READ NEXT:
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL PARKING BRAKE SHOE HOLD DOWN
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during N
SEE MORE:
Power windows
Opening and closing procedures
The power windows can be opened and closed using the switches.
Operating the switch moves the windows as follows:
Closing
One-touch closing*
Opening
One-touch opening*
*: To stop the window partway, operate
the switch in the opposite direction.
Pre
Test Mode Procedure
TEST MODE PROCEDURE SENSOR CHECK USING DEALER MODE (SIGNAL CHECK)
NOTICE:
After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
After replacing or removing and installing a speed
