Toyota Camry (XV70): Parking Support Brake
function (static
objects)
If a collision with an object may occur due to the vehicle suddenly
moving forward due to an accidental accelerator pedal
operation, the vehicle moving the unintended direction due to
the wrong shift position being selected, or while parking or traveling
at low speeds, the sensors detect objects, such as a wall,
in the traveling direction of the vehicle, and the system operates
to lessen an impact with an object and reduce the resulting damage.
Examples of system operation
The system will operate in situations such as the following if an object
is detected in the traveling direction of the vehicle.
■ When traveling at a low speed and the brake pedal is not
depressed, or is depressed late
■ When the accelerator pedal is depressed excessively
■ When the vehicle moves in the unintended direction due to the
wrong shift position being selected
■The Parking Support Brake function (static objects) will operate when
The function will operate when the PKSB OFF indicator is not illuminated
- Engine output restriction control
- The Parking Support Brake system is enabled.
- The vehicle speed is approximately 10 mph (15 km/h) or less.
- There is an object in the traveling direction of the vehicle and
approximately
6 to 13 ft. (2 to 4 m) away.
- The system determines that a stronger-than-normal brake operation is
necessary to avoid a collision.
- Brake control
- Engine output restriction control is operating.
- The system determines that an emergency brake operation is necessary
to avoid a collision.
■The Parking Support Brake function (static objects) will stop operating
when
The function will stop operating if any of the following conditions are met:
- Engine output restriction control
- The Parking Support Brake system is disabled.
- The collision becomes avoidable with normal brake operation.
- The object is no longer approximately 6 to 13 ft. (2 to 4 m) away in
the
traveling direction of the vehicle.
- Brake control
- The Parking Support Brake system is disabled.
- Approximately 2 seconds elapse after the vehicle is stopped by brake
control.
- The brake pedal is depressed after the vehicle is stopped by brake
control.
- The object is no longer approximately 6 to 13 ft. (2 to 4 m) away in
the
traveling direction of the vehicle.
■Detection range of the Parking Support Brake function (static objects)
The detection range of the Parking Support Brake function differs from the
detection range of the intuitive parking assist.
Therefore, even if the intuitive parking assist detects an object and
provides a
warning, the Parking Support Brake function may not start operating.
READ NEXT:
If a radar sensor detects a vehicle approaching from the right or
left at the rear of the vehicle and the system determines that the
possibility of a collision is high, this function will perform br
The driving modes can be selected to suit driving condition.
Normal mode
Use for normal driving.
While in Eco drive mode or sport mode, press the switch to change the
driving mode to norma
SEE MORE:
DESCRIPTION This DTC is stored when the skid control ECU (brake actuator assembly) receives an internal malfunction signal from the steering angle sensor.
DTC No. Detection Item
DTC Detection Condition Trouble Area
C052696 Steering Angle Sensor Module Component Internal Fail
Vehicle load limits include total load capacity, seating capacity,
towing capacity and cargo capacity.
◆ Total load capacity (vehicle capacity weight)
Total load capacity means the combined weight of occupants, cargo
and luggage.
◆ Seating capacity
Seating capacity means the maximum number