Toyota Camry owners & service manuals

Toyota Camry (XV70): Replacement

REPLACEMENT

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during diaphragm oil seal removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Rear wheel alignment adjustment

  • Perform "Reset Memory"
  • Perform acceleration sensor zero point calibration and system information memorization
  • VSC disabled or malfunctioning
  • DTCs are output
  • Slip indicator light illuminated
  • ABS warning light illuminated

Suspension, tires, etc.

(The vehicle height changes because of suspension or tire replacement)

Rear television camera assembly optical axis (Back camera position setting)

Parking assist monitor system

for Initialization

for Calibration

  • Television camera controller initialization
  • Adjust steering angle
  • Rear television camera assembly optical axis (Back camera position setting)

Panoramic view monitor system

for Initialization

for Calibration

Exhaust system parts

Inspection after repair

  • Poor idle, etc.
  • Engine start function, etc.

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

PROCEDURE

1. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY

Click here

2. REMOVE REAR NO. 1 DIFFERENTIAL SUPPORT

Click here

3. REMOVE REAR NO. 2 DIFFERENTIAL SUPPORT

Click here

4. REMOVE TRANSMISSION COUPLING ASSEMBLY

Click here

5. REMOVE TRANSMISSION COUPLING CONICAL SPRING WASHER

Click here

6. REMOVE TRANSMISSION COUPLING SHIM

Click here

7. REMOVE DIAPHRAGM OIL SEAL

(a) Using SST, remove the diaphragm oil seal from the rear differential carrier sub-assembly.

SST: 09308-10010

*1

Diaphragm Oil Seal

*a

Turn

*b

Hold

8. INSTALL DIAPHRAGM OIL SEAL

(a) Coat the lip of a new diaphragm oil seal with MP grease.

(b) Using SST and a hammer, tap the diaphragm oil seal into the rear differential carrier sub-assembly until it reaches the standard value.

SST: 09710-30021

09710-03121

SST: 09950-60011

09951-00570

SST: 09950-70010

09951-07100

Standard distance:

6.5 to 7.5 mm (0.256 to 0.295 in.) (from the edge of the differential carrier sub-assembly)

NOTICE:

  • Tap the oil seal uniformly so that the oil seal is straight.
  • Do not tap the oil seal in too far.

*1

Diaphragm Oil Seal

*a

Distance

9. INSTALL TRANSMISSION COUPLING SHIM

Click here

10. INSTALL TRANSMISSION COUPLING CONICAL SPRING WASHER

Click here

11. INSTALL TRANSMISSION COUPLING ASSEMBLY

Click here

12. INSTALL REAR NO. 1 DIFFERENTIAL SUPPORT

Click here

13. INSTALL REAR NO. 2 DIFFERENTIAL SUPPORT

Click here

14. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

Click here

    READ NEXT:

     Rear Differential Side Gear Shaft Oil Seal

    ComponentsCOMPONENTS ILLUSTRATION *1 REAR DRIVE SHAFT OIL SEAL LH - - ● Non-reusable part MP grease ReplacementREPLACEMENT CAUTION / NOTICE / HINT

     Steering Knuckle

    ComponentsCOMPONENTS ILLUSTRATION *1 FRONT LOWER BALL JOINT ASSEMBLY *2 STEERING KNUCKLE *3 FRONT AXLE HUB SUB-ASSEMBLY *4 FRONT DISC BRAKE DUST COVER *5

     Drive Shaft / Propeller Shaft

    SEE MORE:

     Driving the vehicle

    The following procedures should be observed to ensure safe driving: Driving 1. With the brake pedal depressed, shift the shift lever to D. 2. Release the parking brake. 3. Gradually release the brake pedal and gently depress the accelerator pedal to accelerate the vehicle. Stopping 1. With t

     Sending Malfunction (Navigation to APGS) (U0073,U0100,U0129,U0140,U0155,U0164,U0198,U023B,U0265,U1110)

    DESCRIPTION These DTCs are stored when a malfunction occurs in the CAN communication circuit. DTC No. Detection Item DTC Detection Condition Trouble Area U0073 Sending Malfunction (Navigation to APGS) CAN bus connection error CAN communication system U010

    © 2023-2025 Copyright www.tocamry.com