Toyota Camry (XV70): Steering Angle Sensor Module Calibration / Parameter Memory Failure (C052646)
DESCRIPTION
When the vehicle is being driven in a straight line at 15 km/h (9 mph) for 1 second or more, the skid control ECU (brake actuator assembly) calculates the steering angle sensor zero point and updates the zero point if the difference between the calculated zero point and current zero point is between 10
READ NEXT:
DESCRIPTION This DTC is stored when the skid control ECU (brake actuator assembly) receives an internal malfunction signal from the steering angle sensor.
DTC No. Detection Item
DTC Detec
DESCRIPTION The ABS motor relay is built into the brake actuator assembly.
When the skid control ECU (brake actuator assembly) operates ABS, TRAC, VSC or brake assist, the ABS motor relay turns ON a
DESCRIPTION The ABS motor relay and pump motor are built into the brake actuator assembly.
If the skid control ECU (brake actuator assembly) detects a malfunction in the drive circuit of the pump mo
SEE MORE:
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front lower No. 1 suspension arm sub-assembly removal/installation are shown below. Necessary Procedu
Observe the following precautions when children are in the vehicle.
Use a child restraint system appropriate for the child, until the
child becomes large enough to properly wear the vehicle's seat
belt.
It is recommended that children sit in the rear seats to avoid
accidental
contact w