Toyota Camry (XV70): Theft deterrent system
Toyota Camry Owner's Manual XV70 (2017-2024) / For safety and security / Theft deterrent system
READ NEXT:
Engine immobilizer system
The vehicle's keys have built-in transponder chips that prevent
the engine from starting if a key has not been previously registered
in the vehicle's on-board computer.
Never leave the keys insid
Alarm
The alarm
The alarm uses light and sound to give an alert when an intrusion is
detected.
The alarm is triggered in the following situations when the alarm is
set:
Vehicles without a smart key s
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear upper control arm assembly removal/installation are shown below. Necessary Procedures After Part
Inspection
INSPECTION PROCEDURE 1. INSPECT TIE ROD ASSEMBLY LH
(a) Secure the tie rod assembly LH in a vise between aluminum plates.
NOTICE: Do not overtighten the vise.
(b) Install the nut to the stud bolt. (c) Flip the ball joint back and forth 5 times.
(d) Using a torque wr
© 2023-2026 Copyright www.tocamry.com
