Toyota Camry (XV70): Turn signal lever
Operating instructions
- Right turn
- Lane change to the right (move
the lever partway and release
it)
The right hand signals will flash 3
times.
- Lane change to the left (move
the lever partway and release
it)
The left hand signals will flash 3
times.
- Left turn

■Turn signals can be operated when
Vehicles without a smart key system:
The engine switch is in the "ON" position.
Vehicles with a smart key system:
The engine switch is in IGNITION ON mode.
■If the indicator flashes faster than usual
Check that a light bulb in the front or rear turn signal lights has not
burned
out.
■If the turn signals stop flashing before a lane change has been performed
Operate the lever again.
■To discontinue flashing of the turn signals during a lane change
Operate the lever in the opposite direction.
READ NEXT:
Operating instructions
To set the parking brake, fully
depress the parking brake pedal
with your left foot while depressing
the brake pedal with your right
foot.
(Depressing the pedal again
r
A mode can be selected from the following modes.
Automatic mode
The parking brake is set or released automatically according to the
shift lever operation.
Even when in automatic mode, the parkin
The brake hold system keeps the brake applied when the shift
lever is in D, S or N with the system on and the brake pedal has
been depressed to stop the vehicle. The system releases the
brake when
SEE MORE:
DATA LIST / ACTIVE TEST DATA LIST HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be di
DESCRIPTION
Code Tester Display
Measurement Item Trouble Area
X0452 FR Speed Sensor Wrong Installation
History of front speed sensor RH being installed incorrectly
Front Speed Sensor RH PROCEDURE
1.
CHECK FOR DTCs (HEALTH CHECK) (a) Perform the H