Toyota Camry (XV70): FL Speed Sensor Wrong Installation (X0451)
DESCRIPTION
|
Code | Tester Display |
Measurement Item | Trouble Area |
|---|---|---|---|
|
X0451 | FL Speed Sensor Wrong Installation |
History of front speed sensor LH being installed incorrectly |
Front speed sensor LH |
PROCEDURE
| 1. |
CHECK FOR DTCs (HEALTH CHECK) |
(a) Perform the Health Check using the Techstream.
| Result |
Proceed to |
|---|---|
| DTCs are not output |
A |
| DTCs are output |
B |
| B |
.gif) | GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
.gif)
| 2. |
CHECK PART NUMBER (FRONT SPEED SENSOR LH) |
(a) Check that the front speed sensor LH is installed.
OK:
Proper front speed sensor LH is installed.
NOTICE:
If it is necessary to remove components in order to check the front speed sensor LH, follow the relevant installation and removal procedures and precautions for those components.
| NG | | REPLACE FRONT SPEED SENSOR LH |
|
| 3. |
CLEAR VEHICLE CONTROL HISTORY (RoB) |
(a) Using the Techstream, clear the Vehicle Control History (RoB).
Chassis > Brake > Utility|
Tester Display |
|---|
| Vehicle Control History (RoB) |
|
| 4. |
CHECK VEHICLE CONTROL HISTORY (RoB) |
(a) Using the Techstream, check for Vehicle Control History (RoB).
Chassis > Brake > Utility|
Tester Display |
|---|
| Vehicle Control History (RoB) |
| Result |
Proceed to |
|---|---|
| X0451 is not output |
A |
| X0451 is output |
B |
| A |
| USE SIMULATION METHOD TO CHECK
|
.gif)
| B |
| REPLACE FRONT SPEED SENSOR LH |
READ NEXT:
FR Speed Sensor Wrong Installation (X0452)
DESCRIPTION
Code Tester Display
Measurement Item Trouble Area
X0452 FR Speed Sensor Wrong Installation
History of front speed sensor RH being installed incorrectly
RL Speed Sensor Wrong Installation (X0453)
DESCRIPTION
Code Tester Display
Measurement Item Trouble Area
X0453 RL Speed Sensor Wrong Installation
History of rear speed sensor LH being installed incorrectly
RR Speed Sensor Wrong Installation (X0454)
DESCRIPTION
Code Tester Display
Measurement Item Trouble Area
X0454 RR Speed Sensor Wrong Installation
History of rear speed sensor RH being installed incorrectly
SEE MORE:
Replacement
REPLACEMENT CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transfer case oil seal removal/installation are shown below. Necessary Procedures After Parts Remo
Yaw Rate Sensor Circuit Intermittent (C00631F,C006396,C05201F)
DESCRIPTION The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.
These DTCs are stored when the skid control ECU (brake actuator assembly) receives a malfunction signal from the yaw rate and acceleration sensor (airbag sensor assembly).
