Toyota Camry (XV70): Heated Oxygen Sensor
Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / 2gr-fks (engine Control) / Heated Oxygen Sensor
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 FRONT FLOOR COVER LH
*2 FRONT FLOOR COVER RH
N*m (kgf*cm, ft.*lbf): Specified torque
- - ILLUSTRATION
*1 BODY MOUN
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during he
Inspection
INSPECTION PROCEDURE 1. INSPECT HEATED OXYGEN SENSOR (for Bank 1)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Con
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL LEAK DETECTION PUMP SUB-ASSEMBLY
HINT: Only perform this procedure when replacement of the leak detection pump sub-assembly is necessary.
(a) Engage the 2 claws to install a new leak detection pump sub-assembly to the No. 2 charcoal canister sub-assembly.
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT: Using the Techstream to read the Data List allows the values or state
© 2023-2025 Copyright www.tocamry.com
