Toyota Camry (XV70): Noise Occurs or Sound Skips when Portable Player Plays
CAUTION / NOTICE / HINT
HINT:
- Perform this check with the portable player volume set at an appropriate level.
- Make sure that there are no obstructions between the portable player and the radio and display receiver assembly that may block signals, and that the portable player and the radio and display receiver assembly are not excessively far apart.
- Make sure that devices other than the radio and display receiver assembly are not connected to the portable player.
- Make sure that there is no interference from a wireless LAN, etc.
PROCEDURE
1. | CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL |
(a) Check that the same problem does not occur in the sound heard from the speakers of another "Bluetooth" audio compatible vehicle of the same model.
OK:
The same problem does not occur in the sound heard from the speakers.
NG |
| MALFUNCTION IN PORTABLE PLAYER |
OK |
| |
2. |
REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES |
(a) Remove additional devices which use radio waves.
(b) Play the portable player and check that the same problem does not occur in the sound heard from the speakers.
OK:
The same problem does not occur in the sound heard from the speakers.
OK |
| END |
READ NEXT:
CAUTION / NOTICE / HINT HINT: Some versions of "Bluetooth" compatible audio players may not function properly, or the functions may be limited using the radio and display receiver assembly, even if th
PROCEDURE
1. DELETE OPERATION
(a) Check if a registered portable player can be deleted normally. OK:
Registered portable player can be deleted normally.
OK
END
NG
CAUTION / NOTICE / HINT HINT: Some versions of "Bluetooth" compatible audio players may not function properly, or the functions may be limited using the radio and display receiver assembly, even if th
SEE MORE:
MONITOR DESCRIPTION The engine control unit and the transmission control unit are located inside the ECM. The engine control unit intercommunicates with the transmission control via CAN communication.
If there is a problem in this communication, the ECM store this DTC.
DTC No. Detection It
DESCRIPTION This circuit includes the navigation ECU and radio and display receiver assembly. WIRING DIAGRAM
PROCEDURE
1.
CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)
(a) Disconnect the K1 radio and display receiver assembly connector. (b) Dis