Toyota Camry (XV70): Oil Cooler
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 REAR ENGINE UNDER COVER LH
*2 FRONT FENDER APRON SEAL LH
*3 NO. 1 ENGINE UNDER COVER
*4 FRONT WHEEL OPENING EXTENSION PAD LH
*5
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during tr
Installation
INSTALLATION PROCEDURE 1. INSTALL TRANSMISSION OIL COOLER
(a) Temporarily install the transmission oil cooler to the automatic transaxle case sub-assembly with the bolt (A).
SEE MORE:
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. SEPARATE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP
(a) Secure the drive shaft in a vise between aluminum plates. NOTICE:
Do not ove
Brake Pressure Control Solenoid "C" Control Circuit Short to Battery (C14F112,...,C14FA49)
DESCRIPTION The ABS solenoid relay and reservoir cut solenoid valves are built into the brake actuator assembly.
When the brakes are operating, the reservoir cut solenoid valves supply brake fluid from the brake master cylinder reservoir assembly to the pump motor as necessary.
When this DTC is
© 2023-2024 Copyright www.tocamry.com
