Toyota Camry (XV70): Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
If DTCs are not output but the malfunction persists, use the following table to determine which circuits to inspect for each problem symptom.
HINT:
Refer to each inspection procedure for related problem symptoms.
Vehicle Stability Control System|
Symptom | Suspected Area |
Link |
|---|---|---|
| ABS warning light abnormal (Remains on) |
Refer to the procedure for "ABS Warning Light Remains ON" |
|
|
ABS warning light abnormal (Does not come on) |
Refer to the procedure for "ABS Warning Light does not Come ON" |
|
|
Brake system warning light (red indicator) abnormal (Remains on) |
Refer to the procedure for "Brake Warning Light Remains ON" |
|
|
Brake system warning light (red indicator) abnormal (Does not come on) |
Refer to the procedure for "Brake Warning Light does not Come ON" |
|
|
Slip indicator light abnormal (Remains on) |
Refer to the procedure for "Slip Indicator Light Remains ON" |
|
|
Slip indicator light abnormal (Does not come on) |
Refer to the procedure for "Slip Indicator Light does not Come ON" |
|
|
TRAC does not operate | Refer to the procedure for "TRAC does not Operate" |
|
|
Excessive brake pedal travel (No fluid leaks and no air in system) |
Refer to the procedure for "Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)" |
|
|
ABS operates before necessary when braking |
Refer to the procedure for "ABS Operates Before Necessary When Braking" |
|
|
VSC does not operate or VSC does not operate correctly |
Refer to the procedure for "VSC does not Operate or VSC does not Operate Correctly" |
|
|
Brake actuator operation sound is loud during initial check |
Refer to the procedure for "Brake Actuator Operation Sound is Loud during Initial Check" |
|
|
VSC OFF switch abnormal |
Refer to the procedure for "VSC OFF Switch Circuit" |
|
.gif)
READ NEXT:
Terminals Of Ecu
TERMINALS OF ECU TERMINALS OF ECU
*a Component without harness connected
(Skid Control ECU (Brake Actuator Assembly))
- -
HINT:
As a waterproof connector is used for th
Diagnosis System
DIAGNOSIS SYSTEM DESCRIPTION When troubleshooting a vehicle with a diagnosis system, the only difference from the usual troubleshooting procedure is connecting the Techstream to the vehicle and readin
Dtc Check / Clear
DTC CHECK / CLEAR DTC CHECK (a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3. (c) Turn the ignition switch to ON.
(d) Turn the Techstream on. (e) Read the DTCs following th
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. OPERATION CHECK (a) Slide the clip and disconnect the union to check valve hose from the vacuum pump assembly.
(b) Connect the hose of the vacuum gauge to the vacuum pump assembly.
*a Vacuum Gauge
*b Plug
Steering Angle Sensor (C1297)
DESCRIPTION The 4WD ECU assembly determines that the vehicle is turning based on the signals sent from the steering sensor.
The steering sensor signal is sent to the 4WD ECU assembly via CAN communication.
DTC No. Detection Item
DTC Detection Condition Trouble Area
C1297 S
