Toyota Camry (XV70): RR Speed Sensor Wrong Installation (X0454)
DESCRIPTION
|
Code | Tester Display |
Measurement Item | Trouble Area |
|---|---|---|---|
|
X0454 | RR Speed Sensor Wrong Installation |
History of rear speed sensor RH being installed incorrectly |
Rear Speed Sensor RH |
PROCEDURE
| 1. |
CHECK FOR DTCs (HEALTH CHECK) |
(a) Perform the Health Check using the Techstream.
| Result |
Proceed to |
|---|---|
| DTCs are not output |
A |
| DTCs are output |
B |
| B |
.gif) | GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
.gif)
| 2. |
CHECK PART NUMBER (REAR SPEED SENSOR RH) |
(a) Check that the rear speed sensor RH is installed.
OK:
Proper rear speed sensor RH is installed.
NOTICE:
If it is necessary to remove components in order to check the rear speed sensor RH, follow the relevant installation and removal procedures and precautions for those components.
HINT:
The rear speed sensor RH (for 2WD) and rear speed sensor rotor RH are incorporated into the rear axle hub and bearing assembly RH.
If the rear speed sensor RH (for 2WD) and rear speed sensor rotor RH need to be replaced, replace the rear axle hub and bearing assembly RH.
| NG | | REPLACE REAR SPEED SENSOR RH for 2WD: Click here for AWD: Click here
|
.gif)
|
| 3. |
CLEAR VEHICLE CONTROL HISTORY (RoB) |
(a) Using the Techstream, clear the Vehicle Control History (RoB).
Chassis > Brake > Utility|
Tester Display |
|---|
| Vehicle Control History (RoB) |
|
| 4. |
CHECK VEHICLE CONTROL HISTORY (RoB) |
(a) Using the Techstream, check for Vehicle Control History (RoB).
Chassis > Brake > Utility|
Tester Display |
|---|
| Vehicle Control History (RoB) |
HINT:
The rear speed sensor RH (for 2WD) and rear speed sensor rotor RH are incorporated into the rear axle hub and bearing assembly RH.
If the rear speed sensor RH (for 2WD) and rear speed sensor rotor RH need to be replaced, replace the rear axle hub and bearing assembly RH.
| Result |
Proceed to |
|---|---|
| X0454 is not output |
A |
| X0454 is output |
B |
| A |
| USE SIMULATION METHOD TO CHECK
|
| B |
| REPLACE REAR SPEED SENSOR RH for 2WD: Click here for AWD: Click here
|
READ NEXT:
Yaw Rate Sensor Wrong Installation (X0456)
DESCRIPTION The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.
Code Tester Display
Measurement Item Trouble Area
X0456
Zero Point Calibration of Steering Angle Sensor Initialization Malfunction (X208A)
DESCRIPTION
Code Tester Display
Measurement Item Trouble Area
X208A Zero Point Calibration of Steering Angle Sensor Initialization Malfunction
History of failure in acqu
TRAC does not Operate
DESCRIPTION When TRAC or VSC is operating, the skid control ECU (brake actuator assembly) blinks the slip indicator light to inform the driver that slippage occurred.
When in VSC off mode, or TRAC a
SEE MORE:
Yaw Rate Sensor Circuit Voltage Out of Range (C00631C)
DESCRIPTION The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.
The skid control ECU (brake actuator assembly) calibrates the sensitivity of the yaw rate sensor (airbag sensor assembly) based on signals from the steering angle sensor and sp
If the electronic key does
not operate properly (vehicles with a smart key system)
If communication between the electronic key and vehicle is
interrupted or the electronic key cannot be used
because the battery is depleted, the smart key system and wireless
remote control cannot be used. In such cases, the doors
and trunk can be opened and the engine can be started by followin
