Toyota Camry (XV70): Ultrasonic Sensor (Front Left Corner) Component Internal Failure (C1AE196)
DESCRIPTION
The front corner ultrasonic sensor LH is installed on the front bumper. The clearance warning ECU assembly detects obstacles based on signals it receives from the front corner ultrasonic sensor LH. If an open circuit or other malfunction occurs in the front corner ultrasonic sensor LH, the front corner ultrasonic sensor LH does not operate correctly.
|
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
|---|---|---|---|
|
C1AE196 | Ultrasonic Sensor (Front Left Corner) Component Internal Failure |
Front corner ultrasonic sensor LH failure |
|
CAUTION / NOTICE / HINT
NOTICE:
- Perform registration after replacing or removing and installing the ultrasonic sensor or clearance warning ECU assembly.
Click here
.gif)
- If a DTC is detected again after the repair, turn the ignition switch to ON and turn the intuitive parking assist system on, and then clear the DTC.
Click here
PROCEDURE
|
1. | CHECK FOR DTC |
(a) According to the display on the GTS, check for DTCs.
Body Electrical > Clearance Warning > Trouble Codes(b) According to the display on the GTS, clear the DTCs.
Body Electrical > Clearance Warning > Clear DTCs(c) Recheck for DTCs.
Body Electrical > Clearance Warning > Trouble Codes|
Result | Proceed to |
|---|---|
|
No DTC is output | A |
|
"C1AE196" is output | B |
|
"C1AE196" and "C1AE187" are output |
C |
| A |
.gif) | USE SIMULATION METHOD TO CHECK
|
| C |
| GO TO OTHER FLOWCHART (C1AE187) |
|
.gif)
| 2. |
REPLACE FRONT CORNER ULTRASONIC SENSOR LH |
(a) Replace the front corner ultrasonic sensor LH with a new or normally functioning one.
Click here
HINT:
To check if the ultrasonic sensor is functioning correctly, replace it with another ultrasonic sensor.
|
| 3. |
CHECK FOR DTC |
(a) According to the display on the GTS, check for DTCs.
Body Electrical > Clearance Warning > Trouble Codes(b) According to the display on the GTS, clear the DTCs.
Body Electrical > Clearance Warning > Clear DTCs(c) Recheck for DTCs.
Body Electrical > Clearance Warning > Trouble Codes|
Result | Proceed to |
|---|---|
|
No DTC is output | A |
|
"C1AE196" is output | B |
| A |
| END (FRONT CORNER ULTRASONIC SENSOR LH WAS DEFECTIVE) |
| B |
| REPLACE CLEARANCE WARNING ECU ASSEMBLY |
READ NEXT:
Ultrasonic Sensor (Front Left Center) Missing Message (C1AE287)
DESCRIPTION This DTC is stored when an open circuit or short occurs in the communication line between the front center ultrasonic sensor LH and the front center ultrasonic sensor RH, or when a malfunc
Ultrasonic Sensor (Front Left Center) Component Internal Failure (C1AE296)
DESCRIPTION The front center ultrasonic sensor LH is installed on the front bumper. The clearance warning ECU assembly detects obstacles based on signals it receives from the front center ultrasonic s
Ultrasonic Sensor (Front Right Center) Missing Message (C1AE387)
DESCRIPTION This DTC is stored when an open circuit or short occurs in the communication line between the front center ultrasonic sensor RH and the front corner ultrasonic sensor RH, or when a malfunc
SEE MORE:
Wheel Speed Sensor Signal Compare Failure (C124E62)
DESCRIPTION The skid control ECU (brake actuator assembly) measures the speed of each wheel by receiving signals from each speed sensor.
These signals are used for recognizing that all four wheels are operating properly.
Therefore, signals from all wheels must be equal.
DTC No. Detection
Front Disc Brake Pad (for 2-pot Caliper)
ComponentsCOMPONENTS ILLUSTRATION
*1 FRONT DISC BRAKE ANTI-SQUEAL SHIM KIT
*2 FRONT DISC BRAKE PAD
*3 FRONT DISC BRAKE CYLINDER ASSEMBLY
*4 FRONT DISC BRAKE PAD WEAR INDICATOR PLATE
*5 FRONT NO. 1 DISC BRAKE ANTI-SQUEAL SHIM
*6 FRONT NO. 2 DISC
