Toyota Camry (XV70): Vehicle Speed Sensor (C1A45)
DESCRIPTION
The blind spot monitor sensor receives vehicle speed signals from the skid control ECU via CAN communication.
Blind Spot Monitor Master|
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
|---|---|---|---|
|
C1A45 | Vehicle Speed Sensor |
A fail flag is transmitted from the skid control ECU |
|
|
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
|---|---|---|---|
|
C1A45 | Vehicle Speed Sensor |
A fail flag is transmitted from the skid control ECU |
|
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
PROCEDURE
| 1. |
CHECK OTHER DTC OUTPUT (VEHICLE STABILITY CONTROL SYSTEM) |
(a) Check for vehicle stability control system DTCs.
w/o Electric Parking Brake System: Click here
.gif)
w/ Electric Parking Brake System: Click here
OK:
Vehicle stability control system DTCs are not output.
| NG | .gif) | GO TO VEHICLE STABILITY CONTROL SYSTEM Click here w/ Electric Parking Brake System: Click here
w/o Electric Parking Brake System: Click here
|
|
.gif)
| 2. |
CHECK DTC |
(a) Turn the engine switch off.
(b) Turn the engine switch on (IG).
(c) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes|
Result | Proceed to |
|---|---|
|
No DTCs are output | A |
|
DTC C1A45 is output ("Blind Spot Monitor Master") |
B |
| DTC C1A45 is output ("Blind Spot Monitor Slave") |
C |
| A |
| USE SIMULATION METHOD TO CHECK
|
| B |
| REPLACE BLIND SPOT MONITOR SENSOR RH
|
| C |
| REPLACE BLIND SPOT MONITOR SENSOR LH
|
READ NEXT:
Yaw Rate Sensor (C1A46)
DESCRIPTION The blind spot monitor sensor receives yaw rate signals from the airbag sensor assembly (yaw rate and acceleration sensor) via CAN communication. Blind Spot Monitor Master
DTC No.
Steering Angle Sensor (C1A47)
DESCRIPTION The blind spot monitor sensor receives steering angle signals from the steering sensor via CAN communication. Blind Spot Monitor Master
DTC No. Detection Item
DTC Detection Co
Short to +B in Outer Mirror Indicator(Master) (C1AB0)
DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects a short to +B in the outer rear view mirror indicator RH.
DTC No. Detection Item
DTC Detection Condition Tro
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT
NOTICE:
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
After replacing the front disc brake pads, always perform a road test to chec
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during clearance warning ECU assembly removal/installation are shown below. Necessary Procedure After Parts
