Toyota Camry (XV70): Data List / Active Test
DATA LIST / ACTIVE TEST
DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Navigation System / Data List.
(e) Read the Data List according to the display on the Techstream.
Body Electrical > Navigation System > Data List|
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Battery Voltage | Battery voltage |
Min.: 0 V, Max.: 24 V | 11 to 14 V |
- |
| Active Dimmer |
Active dimmer function |
ON or OFF | ON: Active dimmer function on OFF: Active dimmer function off |
- |
| Tail Light SW |
Taillight switch | ON or OFF |
ON: Light control switch in tail or head position OFF: Light control switch off or AUTO |
- |
| Reverse Signal |
Reverse signal | ON or OFF |
ON: Shift lever in R OFF: Shift lever not in R |
- |
| Parking Brake |
Parking brake switch | ON or OFF |
ON: Parking brake applied OFF: Parking brake released |
- |
| Ignition |
Engine switch | ON or OFF |
ON: Engine switch on (IG) OFF: Engine switch off |
- |
| Vehicle Speed |
Maximum wheel speed sensor reading |
Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) |
Vehicle stopped: 0 km/h (0 mph) |
When driving at constant speed: No large fluctuations |
|
HDMI Line(Blu-ray Disc Player) |
- | Disconnected or Connected |
Disconnected | Not available |
READ NEXT:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Navigation System
DTC No. Detection Item
Link B1324
Lost Communication with Meter
B1325 Lost Communication with HUD
Lost Communication with Meter (B1324,B1325)
DESCRIPTION These DTCs are stored when communication between the radio and display receiver assembly and combination meter assembly or headup display (meter mirror sub-assembly)* is not possible.
GVIF Disconnected (from Extension Module to H/U) (B153A)
DESCRIPTION
DTC No. Detection Item
DTC Detection Condition Trouble Area
B153A GVIF Disconnected (from Extension Module to H/U)
GVIF disconnected (from navigation ECU to
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT DRIVE SHAFT ASSEMBLY
(a) Check that there is no excessive play in the radial direction of the outboard joint.
(b) Check that the inboard joint slides smoothly in the thrust direction.
(c) Check that there is no excessive play in the
Replacement
REPLACEMENT CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during diaphragm oil seal removal/installation are shown below. Necessary Procedures After Parts Removed
