Toyota Camry (XV70): Knock Sensor
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 KNOCK CONTROL SENSOR (for Bank 1)
*2 KNOCK CONTROL SENSOR (for Bank 2)
N*m (kgf*cm, ft.*lbf): Specified torque
* For use with a un
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during kn
Inspection
INSPECTION PROCEDURE 1. INSPECT KNOCK CONTROL SENSOR
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
SEE MORE:
Lost Communication with Sliding Sunshade ECU (B2329)
DESCRIPTION This DTC is stored when LIN communication between the roof sunshade ECU (sliding roof drive gear assembly) and main body ECU (multiplex network body ECU) stops for 10 seconds or more.
DTC No. Detection Item
DTC Detection Condition Trouble Area
B2329 Lost Communic
Control Module Communication Bus Off (U0073,U0100,U0126,U0129)
DESCRIPTION The 4WD ECU assembly inputs the signals sent from the ECM, skid control ECU (brake actuator assembly) and steering sensor via CAN communication.
When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each correspondi
© 2023-2026 Copyright www.tocamry.com
