Toyota Camry (XV70): Red Indicator Remains On
DESCRIPTION
This means that the DCM (telematics transceiver) has detected a malfunction in the safety connect system and stored a DTC or specific vehicle control history (RoB) Code.
PROCEDURE
| 1. |
CHECK DTC |
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch on (IG) and wait for 10 seconds or more.
(d) Turn the Techstream on.
(e) Clear the DTCs.
Body Electrical > Telematics > Clear DTCs(f) Check for DTCs and check that no DTCs are output.
Body Electrical > Telematics > Trouble CodesOK:
No DTCs are output.
| NG | .gif) |
GO TO DIAGNOSTIC TROUBLE CODE CHART
|
|
.gif)
| 2. |
CHECK VEHICLE OPERATION HISTORY |
(a) Check for vehicle control history and note any codes that are output.
Click here .gif)
|
Result | Proceed to |
|---|---|
|
No vehicle control history is output |
A |
| Any vehicle control history is output |
B |
| B |
| GO TO VEHICLE CONTROL HISTORY |
|
| 3. |
REPLACE DCM (TELEMATICS TRANSCEIVER) |
(a) Replace the DCM (telematics transceiver) with a new one.
Click here
NOTICE:
- The engine switch must be off.
- Do not exchange the DCM (telematics transceiver) with one from another vehicle.
| NEXT | | PERFORM DCM ACTIVATION |
READ NEXT:
Unable To Connect To Call Center
DESCRIPTION This may occur when the intensity of telephone radio frequency was very weak, or the safety connect system has a malfunction and a DTC is set. PROCEDURE
1.
CHECK COMMUNICATION S
Emergency Call Switch Illumination Circuit
WIRING DIAGRAM w/ Sliding Roof
w/o Sliding Roof
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization
Telephone And Gps Antenna (for Front Side)
ComponentsCOMPONENTS ILLUSTRATION
*1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
*2 NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY
*3 TELEPHONE AND GPS ANTENNA ASSEMBLY
*4
SEE MORE:
Brake System Control Module "A" System Voltage System Voltage High (C137BA3)
DESCRIPTION If a malfunction is detected in the power supply circuit, the skid control ECU (brake actuator assembly) stores this DTC and the fail-safe function prohibits ABS operation.
This DTC is stored when the +BS terminal voltage deviates due to a malfunction in a power supply or charging syst
Tire And Wheel
ComponentsCOMPONENTS ILLUSTRATION
*A for Steel Wheel
*B except Steel Wheel
*1 WHEEL ASSEMBLY
*2 AXLE HUB NUT
*3 WHEEL CAP
- -
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping"
