Toyota Camry owners & service manuals

Toyota Camry (XV70): Engine Circuit Malfunction (C1280)

Toyota Camry Repair Manual XV70 (2018-2024) / Drivetrain / Gf1a (transfer / 4wd / Awd) / Dynamic Torque Control Awd System / Engine Circuit Malfunction (C1280)

DESCRIPTION

If a malfunction in the ECM circuit occurs, the 4WD ECU assembly will output this DTC.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1280

Engine Circuit Malfunction

When the following continues for 5 seconds or more:

  • Communication with ECM is operating normally, but engine control system is malfunctioning.
  • Engine control system
  • 4WD ECU assembly

PROCEDURE

1.

CHECK FOR DTC (ENGINE CONTROL SYSTEM)

(a) Check if the engine control system DTC is output.

Powertrain > Engine > Trouble Codes

Result

Proceed to

Engine control system DTC is not output

A

Engine control system DTC is output

B
A

REPLACE 4WD ECU ASSEMBLY

B

GO TO ENGINE CONTROL SYSTEM (DIAGNOSTIC TROUBLE CODE CHART)

    READ NEXT:

     ABS Malfunction (C1296)

    DESCRIPTION If a malfunction in the speed sensor signal circuit or yaw rate and acceleration sensor (airbag sensor assembly) circuit occurs, the 4WD ECU assembly will output this DTC. The airbag sen

     Steering Angle Sensor (C1297)

    DESCRIPTION The 4WD ECU assembly determines that the vehicle is turning based on the signals sent from the steering sensor. The steering sensor signal is sent to the 4WD ECU assembly via CAN communi

     Linear Solenoid Circuit (C1298)

    DESCRIPTION The 4WD ECU assembly receives signals from each sensor to control clutch fluid pressure for limiting the center differential operation, which distributes torque according to the driving co

    SEE MORE:

     Terminals Of Ecu

    TERMINALS OF ECU CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY (a) Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly. Click here (b) Reconnect the instrument panel junction block assembly c

     Reassembly

    REASSEMBLY CAUTION / NOTICE / HINT CAUTION: If the rear disc brake cylinder assembly has been disassembled, perform air bleeding for the rear disc brake cylinder assembly. Click here NOTICE: Make sure not to scratch, damage or apply excessive force to any of the internal components of th

    © 2023-2026 Copyright www.tocamry.com