Toyota Camry (XV70): Telephone Sub Antenna Circuit Short to Ground (B153711,B153713)
DESCRIPTION
These DTCs are stored when a malfunction occurs in the telephone and GPS antenna (for Front Side).
|
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
|---|---|---|---|
|
B153711 | Telephone Sub Antenna Circuit Short to Ground |
Telephone antenna (sub) impedance (Ω) is lower than the malfunction threshold for 10 seconds or more when the engine switch is on (IG) (Short circuit) |
|
| B153713 |
Telephone Sub Antenna Circuit Open |
Telephone antenna (sub) impedance (Ω) is lower than the malfunction threshold for 10 seconds or more when the engine switch is on (IG) (Open circuit) |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Safety Connect System.
Click here .gif)
HINT:
Refer to "PARTS LOCATION" for the installation location of telephone and GPS antenna cord.
Click here
PROCEDURE
| 1. |
CHECK DTC |
(a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the engine switch is on (IG) and wait for 10 seconds or more.
(d) Turn the Techstream on.
(e) Clear the DTCs.
Body Electrical > Telematics > Clear DTCs(f) Check for DTCs and check that no DTCs are output.
Body Electrical > Telematics > Trouble CodesOK:
No DTCs are output.
| OK | .gif) |
CHECK FOR INTERMITTENT PROBLEMS |
|
.gif)
| 2. |
INSPECT TELEPHONE AND GPS ANTENNA ASSEMBLY (for Front Side) |
(a) Remove the navigation antenna assembly.
Click here
(b) Inspect the navigation antenna assembly.
Click here
| NG | | REPLACE TELEPHONE AND GPS ANTENNA ASSEMBLY (for Front Side) |
|
| 3. |
INSPECT TELEPHONE AND GPS ANTENNA CORD (for Type A) |
| (a) Disconnect the F telephone and GPS antenna cord (for Type A) connector. |
|
| (b) Disconnect the E telephone and GPS antenna cord (for Type A) connector. |
|
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection | Condition |
Specified Condition |
|---|---|---|
|
F-4 - E-3 | Always |
Below 1 Ω |
|
F-4 or E-3 - Body ground |
Always | 10 kΩ or higher |
|
F-4a - E-3a | Always |
Below 1 Ω |
|
F-4a or E-3a - Body ground |
Always | 10 kΩ or higher |
| NG | | REPLACE TELEPHONE AND GPS ANTENNA CORD (for Type A) |
|
| 4. |
INSPECT TELEPHONE AND GPS ANTENNA CORD (for Type B) |
| (a) Disconnect the D telephone and GPS antenna cord (for Type B) connector. |
|
| (b) Disconnect the A telephone and GPS antenna cord (for Type B) connector. |
|
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
|
Tester Connection | Condition |
Specified Condition |
|---|---|---|
|
D-3 - A-1 | Always |
Below 1 Ω |
|
D-3 or A-1 - Body ground |
Always | 10 kΩ or higher |
|
D-3a - A-1a | Always |
Below 1 Ω |
|
D-3a or A-1a - Body ground |
Always | 10 kΩ or higher |
| NG | | REPLACE TELEPHONE AND GPS ANTENNA CORD (for Type B) |
|
| 5. |
REPLACE DCM (TELEMATICS TRANSCEIVER) |
(a) Replace the DCM (telematics transceiver) with a new one.
Click here
NOTICE:
- The engine switch must be off.
- Do not exchange the DCM (telematics transceiver) with one from another vehicle.
| NEXT | | PERFORM DCM ACTIVATION |
READ NEXT:
Indicator (Red) Circuit Short to Ground (B157011,B157013)
DESCRIPTION This DTC is stored when the DCM (telematics transceiver) detects an open or short in the manual (SOS) switch red indicator circuit of the manual (SOS) switch.
The manual (SOS) switch red
Indicator (Green) Circuit Short to Ground (B157111,B157113)
DESCRIPTION This DTC is set when the DCM (telematics transceiver) detects an open or short in the manual (SOS) switch green indicator circuit of the manual (SOS) switch. The manual (SOS) switch green
Microphone Circuit Open (B157213)
DESCRIPTION This DTC is stored when the DCM (telematics transceiver) detects a malfunction in the telephone microphone assembly circuit.
DTC No. Detection Item
DTC Detection Condition T
SEE MORE:
Speed Signal Malfunction (B15C2)
DESCRIPTION The navigation ECU receives a vehicle speed signal from the combination meter assembly and information from the navigation antenna assembly, and then adjusts the vehicle position on the map.
The navigation ECU stores this DTC when the difference between the speed information that the n
Precaution
PRECAUTION IGNITION SWITCH EXPRESSION HINT:
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
Expression Ignition Switch (Position)
Engine Switch (Condition)
