Toyota Camry (XV70): Propeller Shaft Assembly
Toyota Camry Repair Manual XV70 (2018-2024) / Drivetrain / Drive Shaft / Propeller Shaft / Propeller Shaft Assembly
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 FRONT LOWER NO. 1 FLOOR HEAT INSULATOR
- -
N*m (kgf*cm, ft.*lbf): Specified torque
- - ILLUSTRATION
*1 PROPELLER W
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during p
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT
NOTICE:
As imbalance affects vibration and noise performance, make sure to ensure correct angular alignment of the following components during installation.
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT BRAKE DISC INSIDE DIAMETER
(a) Using a brake drum gauge or an equivalent tool, measure the inside diameter of the rear disc.
Standard Inside Diameter: 173 mm (6.81 in.) Maximum Inside Diameter:
174 mm (6.85 in.) If the inside diameter is more than the ma
Brake System Control Module "A" System Voltage System Voltage Low (C137BA2)
DESCRIPTION If a malfunction is detected in the power supply circuit, the skid control ECU (brake actuator assembly) stores this DTC and the fail-safe function prohibits ABS operation.
This DTC is stored when the +BS terminal voltage meets one of the DTC detection conditions due to a malfunction i
© 2023-2025 Copyright www.tocamry.com
